DIY halloween skull bracelet

Halloween is getting closer and closer and it’s time to start DIY’ing! In this post I’ll show you how to make this really easy skull bracelet. Time to get spooky! 

Supplies

Step 1

Start by measuring your wrist and by cutting two pieces of the satin cord. These pieces need to fit around your wrist. Use some tape to stick them to the table.

IMG_0195

step 2

Make ten macrame knots (square knots) and then attach a jump ring. Make another ten knots and add another jump ring. Do this until you have four jump rings attached to your bracelet.

output_rDujzY

IMG_0213

step 3

Now cut off the access satin cord and put a small drop of glue at each end of the bracelet, then put the end clasp on it. Make sure you squeeze it hard otherwise it might fall off.

IMG_0214

Step 4

Put one of the skull beads on a head pin and make a small loop at the top of the headpin. Now attach the headpin with the loop to one of the jump rings you knotted in your bracelet. Repeat this with the rest of your skull beads.

Schermafbeelding 2015-10-19 om 20.36.20

IMG_0217

Step 5

Use a jump ring to attach the lobster clasp on one side of the bracelet and attach the extension chain to the other side of the bracelet.

And with that you’re…

DONE! 

IMG_0220

IMG_0225

IMG_0230

Advertisements

4 thoughts on “DIY halloween skull bracelet

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s